Pellta One
3D modeling | branding | product development
Pellta One is a security device for active data protection that protects from unauthorized access to audio and video data. A core part of the design was its simplicity, to make it accessible for a wide range of users. It’s simplicity allows an easily integration into the daily routine of any work environment. Inside Pellta One, a signal algorithm actively prevents the phone’s microphones from picking up and passing on acoustic signals and conversations. The phone remains on reception. Incoming messages and calls can still be heard.
Pellta One is a security device for active data protection that protects from unauthorized access to audio and video data. A core part of the design was its simplicity, to make it accessible for a wide range of users. It’s simplicity allows an easily integration into the daily routine of any work environment. Inside Pellta One, a signal algorithm actively prevents the phone’s microphones from picking up and passing on acoustic signals and conversations. The phone remains on reception. Incoming messages and calls can still be heard.
In the context of cybersecurity, each smartphone is a potential thread.
The problem lies in the deep layer of software and hardware.
Software / Apps
Operation System
Firmware
Hardware / Chip’s
Software / Apps
Operation System
Firmware
Hardware / Chip’s
The counter signal of Pellt-One prevents the Smartphones from recording usable audio signals.
Key Features
Smartphone camera
disabled
Smartphone microphones
disabled
Smartphone connectivity
guaranteed
Safe for all common
Smartphones
"The grey Pellta One aluminium box makes the hacking of smartphone mics and cameras impossible."
"Pellta develops a technical storage box that actively protects all phones placed in it from being tapped."
Safety Icons
Do not use near an
open flame
Do not use on damp surfaces
Do not use with damaged seal
Do not bring magnets near the open device
Do not open or repair the device yourself
Do not use with damaged cable
commissioning
1.
Connect the unit to the included power supply
2.
Set the main switch to position I (ON)
3.
Open the lid upwards along the rear axis
4.
Place up to two phones on the tray’s
5.
Close the lid and pay attention to the sealing
6.
Check the indicator LED on the front.
Do's
The device is suitable for a maximum of two
smartphones
For best protection, remove the case from the smartphone
Check the seal regularly for damage or imperfections
Check the acoustic signal by disconnecting the power supply
Check the function of the green indicator LED on the front
You can clean the device with a dry microfiber cloth
Dont's
Dont's
Always place the telephones parallel to the unit in the tray
The phones must have a minimum distance of 5 mm to each side
Cases that completely enclose the phone must be removed
When closed, the lid must lie flat and over the entire surface
Do not clean with wet cloths or a lot of water
Do not use aggressive
or abrasive cleaners